Install OLIMEXINO-328
by LadyMM
The olimexino-328 is an arduino-like borad, which runs programs called
“sketches”. The programs themselves are written in C/C++ and compiled in the
Arduino environment and then uploaded to the board’s memory via miniUSB.
Special drivers and settings are needed, however, for your computer to
correctly recognise the board. Installation instructions are below.
1.Installation of the arduino-based board
(Instrusctions and screenshots from Limor Fried
http://www.ladyada.net/learn/arduino)
Visit
http://www.ftdichip.com/Drivers/VCP.htm
for the latest drivers for your
Olimexino-328
board
(Instructions for other arduino boards can be found at
http://arduino.cc/en/Guide/HomePage
)
Windows:
(The screenshots show a Windows XP machine, but the installation is the same for
XP/Vista/Windows7)
When you plug in the Arduino, you may hear a sound from the computer and a
little popup bubble in the bottom right corner of the screen that says Found New
Hardware FT232R USB UART
After a few seconds, the new hardware wizard will start. Select "No not this
time" and click Next>
At the next screen, select Install from a list or specific location
At the next screen make sure Include this location is selected and browse to the
folder that contains the driver you downloaded. Select the folder and click OK
It should copy some files and then come up with this window. Click Finish
Almost immediately, another window will pop up, this time it will say USB Serial
Port. As before, click Install from a list or specific location
Browse to the same folder again...
And it should complete successfully!
You may need to reboot the computer.
When the computer is done rebooting, make sure the Arduino is plugged in (and
the green light is lit). Go to the Device Manager (From the Start Menu, select
Settings->Control Panel. Double click on System and select the Hardware tab.
Then click on the Device Manager button)
嵌入式系统
