The TPS6110x devices provide a complete power supply solution for products powered by either one or twoAlkaline, NiCd, or NiMH battery cells. The converter generates two stable output voltages that are either adjustedby an external resistor divider or fixed internally on the chip. It stays in operation with supply voltages down to0.8 V. The implemented boost converter is based on a fixed frequency, pulse-width-modulation (PWM) controllerusing a synchronous rectifier to obtain maximum efficiency.The maximum peak current in the boost switch is limited to a value of 1800 mA.The converter can be disabled to minimize battery drain. During shutdown, the load is completely disconnectedfrom the battery. An auto discharge function allows discharging the output capacitors during shutdown mode.This is especially useful in microcontroller applications where the microcontroller or microprocessor should notremain active due to the stored voltage on the output capacitors. Programming the ADEN-pin disables thisfeature. A low-EMI mode is implemented to reduce ringing and in effect lower radiated electromagnetic energywhen the converter enters the discontinuous conduction mode. A power good output at the boost stage providesadditional control of cascaded power supply components.The built-in LDO can be used for a second output voltage derived either from the boost output or directly fromthe battery. The output voltage of this LDO can be programmed by an external resistor divider or is fixedinternally on the chip. The LDO can be enabled separately i.e., using the power good of the boost stage.The device is packaged in a 20-pin TSSOP (20 PW) package or in a 24-pin QFN (24 RGE) package.