[求助] J-link sw模式不能下载程序

sciencekn1 2016-1-3 16:51 楼主

Load "..\\ObjFlash\\FreezeThawMachine.axf"
Set JLink Project File to "D:\¶3èú»ú\code\FreezeThawMachine20160103\APP\JLinkSettings.ini"
* JLink Info: Device "STM32F103ZE" selected.

JLink info:
------------
DLL: V5.10f, compiled Dec 22 2015 14:24:20
Firmware: J-Link ARM V8 compiled Nov 28 2014 13:44:46
Hardware: V8.00
S/N : 304427288
Feature(s) : RDI,FlashDL,FlashBP,JFlash,GDBFULL

* JLink Info: Found SWD-DP with ID 0x1BA01477
* JLink Info: Found SWD-DP with ID 0x1BA01477
* JLink Info: Found Cortex-M3 r1p1, Little endian.
* JLink Info: FPUnit: 6 code (BP) slots and 2 literal slots
* JLink Info: CoreSight components:
* JLink Info: ROMTbl 0 @ E00FF000
* JLink Info: ROMTbl 0 [0]: FFF0F000, CID: B105E00D, PID: 001BB000 SCS
* JLink Info: ROMTbl 0 [1]: FFF02000, CID: B105E00D, PID: 001BB002 DWT
* JLink Info: ROMTbl 0 [2]: FFF03000, CID: B105E00D, PID: 000BB003 FPB
* JLink Info: ROMTbl 0 [3]: FFF01000, CID: B105E00D, PID: 001BB001 ITM
* JLink Info: ROMTbl 0 [4]: FFF41000, CID: B105900D, PID: 001BB923 TPIU-Lite
* JLink Info: ROMTbl 0 [5]: FFF42000, CID: B105900D, PID: 101BB924 ETM-M3
ROMTableAddr = 0xE00FF003
hi 大家好，错误信息如下
Target info:
------------
Device: STM32F103ZE
VTarget = 3.293V
State of Pins:
TCK: 0, TDI: 0, TDO: 0, TMS: 1, TRES: 1, TRST: 1
Hardware-Breakpoints: 6
Software-Breakpoints: 8192
Watchpoints: 4
JTAG speed: 50 kHz

**JLink Warning: T-bit of XPSR is 0 but should be 1. Changed to 1.
***JLink Error: Communication timed out: Requested 4 bytes, received 0 bytes !
**JLink Warning: Could not read memory location 0x20000000 when trying to set soft RAM BP
Cannot setup Breakpoint at Address
**JLink Warning: Could not read memory location 0x20000000 when trying to set soft RAM BP
Cannot setup Breakpoint at Address
Erase Failed!

之前用这块板子的时候可以下载，但是今天用的时候不能下载了，我把jlink接在别的开发板上下载是可以的