Winding Temperature Rise (at Rated Current): 60°C (max.)
Continued on the following page.
oThis
data sheet is applied for AC Line Filters Hybrid Choke Coils used for General Electronics equipment for your design.
!Note:
1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it
may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering.
2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product
specifications or transact the approval sheet for product specifications before ordering.
2012.7.5
http://www.murata.com/
Noise Suppression Products/EMI Suppression Filters > AC Line Filters > Hybrid Choke Coils
Data Sheet
Continued from the preceding page.
2
PLY10 Series Sectional Winding Type
c
Dimensions
18 max.
16 max.
3.5±1
17.5 max.
ø0.9 max.
10±0.5
(4)
[(1)]
(3)
[(2)]
(in mm)
13±0.5
(1)
[(2)]
(4)
[(3)]
c
Common Mode Insertion Loss-Frequency Characteristics
Winding Temperature Rise (at Rated Current): 60°C (max.)
Continued on the following page.
oThis
data sheet is applied for AC Line Filters Hybrid Choke Coils used for General Electronics equipment for your design.
!Note:
1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it
may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering.
2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product
specifications or transact the approval sheet for product specifications before ordering.
2012.7.5
http://www.murata.com/
Noise Suppression Products/EMI Suppression Filters > AC Line Filters > Hybrid Choke Coils
Data Sheet
Continued from the preceding page.
3
c
Equivalent Circuit
c
Packaging
Code
M
Differential Mode Inductor
Packaging
Magazine
Box
Minimum Quantity
1800
1200
B
(1)
(2)
(4)
Common Mode Inductor
(3)
No polarity.
c !Caution
(Rating)
1. Rated Current
Operating current should not exceed the rated
value. Even if operating current is under the
rated value, adequate ventilation is required to
avoid excessive heat generated within the product
(choke coil) and from surrounding heat sources.
If exceeding these conditions, excessive heat may
cause fumes or permanent damage to the product.
Please ensure that product (choke coil) is
evaluated and confirmed against the specification
when it is mounted in your final assembled product.
-> Winding temperature should be less than
120 degree C.
*As for FKOB series winding temperature should be
less than 95 degree C.
Maximum allowable temperature at the surface of
coil (ambient temperature + winding temperature
rise) is in accordance with each safety standard
applicable to final assembled product.
When the temperature at winding exceeds maximum
allowable temperature of safety standard, the
rated current should be derated.
2. Inrush Current
Inrush current should not exceed 10 times rated
current within 1/4 cycle of 50/60Hz commercial
power line. Inrush current should be limited to a
minimum of 10 seconds after last inrush.
If these conditions are exceeded, excessive heat may
cause fumes or permanent damage to the component,
or at worst cause ignition.
c
Notice (Soldering and Mounting)
Magnetic Flux Leakage
Choke coils generate small amounts of magnetic flux
leakage that may adversely affect equipment operation
according to component arrangement.
Testing should be completed on final assembly to
ensure equipment performance is not affected.
c
Notice (Other)
Coil Humming Noise
Magnetic flux generated between coil and core or
between the choke coil windings creates repulsive
power between the coil windings. This repulsive
power causes the coil winding to vibrate and create
a humming noise. The amount of hum produced by the
coil is proportionate to the amount of harmonic
distortion generated by the operating current. This
does not influence the electrical performance of
the coils, but it should be considered and tested
in actual circuit application.
oThis
data sheet is applied for AC Line Filters Hybrid Choke Coils used for General Electronics equipment for your design.
!Note:
1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it
may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering.
2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product
specifications or transact the approval sheet for product specifications before ordering.
3 月 25 日消息，英特尔与 Arm 近日签署谅解备忘录，确认了在“新兴企业支持计划”上的合作。该计划最初于 2 月的 Intel Foundry Direct Connect 活动上公布。 根据该计划，双方将联手支持初创企业基于 Intel 18A 制程工艺开发 Arm 架构 SoC。 具体而言，英特尔和 Arm 将在 IP 和制造上共同向创企给予支持，同时提供财政援助，以促进这些企业的创新...[详细]
在FreeRTOS中，队列是实现任务之间同步、互斥和通信的一种重要方法（其他的实现方法有：任务通知、事件组、信号量、互斥量）。 任何任务都可以向队列里存放任何数据，任何任务也可以从队列里读取数据，实现不同任务之间的通信。 1 队列特性 队列的数据的操作采用先进先出的方法(FIFO，First In First Out)：写数据时放到尾部，读数据时从头部读，逻辑顺序如下图所示。 ...[详细]
一、改变界面显示的坐标 在播放视频的时候，视频都是从,（0,0）坐标开始播放，要改变坐标的话，按下面操作： 通过对vo_fbdev.c里面的：（vo_fbdev.c这个文件在mplayer安装目录的libvo目录下） static int draw_slice(uint8_t *src , int stride , int w, int h, int x, int y)...[详细]
RF/无线
