D
B
A
B
A
C
C
E
10.
1. - 2.
3.
7. - 9.
ASSEMBLY INSTRUCTIONS:
1. PRE-FOLD ALL SCORES AND PUNCH OUT SLOTTED SECTIONS ON THE BASE CONTAINER.
PUNCH FROM THE OUTSIDE ( PRINTED SIDE ) TOWARDS THE INSIDE OF THE BASE
CONTAINER.
2. FOLD UP SIDE PANELS (A) AND FOLD IN THE BACK (B) AND FRONT FLAPS (C).
3. FOLD THE BACK PANEL (D) OVER THE BACK FLAPS (B) AND TUCK THE TABS INTO THE
SLOTS.
4. FOLD THE FRONT PANEL (E) OVER THE FRONT FLAPS (C) AND TUCK THE TABS INTO THE
SLOTS.
5. TAKE THE LARGE PARTITION (F) AND FOLD ALONG THE TWO SCORE LINES. FOLD SO THAT
THE SCORE ARE INSIDE WHEN FOLDED. REPEAT UNTIL ALL LARGE PARTITIONS (F) ARE
FOLDED.
6. PUNCH OUT THE SLOTTED SECTIONS OF THE SMALL PARTITION (G). FOLD THE SMALL
PARTITION ALONG THE TWO SCORE LINES. FOLD SO THAT THE SCORE LINES ARE INSIDE
WHEN FOLDED.
7. TAKE THE FOLDED LARGE PARTITION (F) AND LINE UP THE BACK SLOT WITH THE END
SLOT ON THE FOLDED SMALL PARTITION (G). PUSH TOGETHER TO LOCK IN PLACE.
8. TAKE AN ADDITIONAL FOLDED LARGE PARTITION (F) AND LINE UP THE BACK SLOT WITH
THE OPPOSITE END OF THE SMALL PARTITION (G). PUSH TOGETHER TO LOCK IN PLACE.
9. TAKE THE PARTIALLY ASSEMBLED PARTITION SET AND PLACE INSIDE THE ASSEMBLED
CONTAINER. ALIGN THE FRON SLOTS OF THE LARGE PARTITION WITH THE SLOTS AT THE
FRONT OF THE BASE CONTAINER. PUSH TOGETHER TO LOCK IN PLACE. MAKE SURE THAT
THE FRONT FLAP (C) IS AGAINST THE FRONT EDGE OF THE BASE CONTAINER AND DOES
NOT INTERFERE WITH THE LOCKING OF THE PARTITIONS AT THE FRONT OF THE BASE
CONTAINER.
10. INSERT THE REMAINING FOLDED LARGE PARTITIONS INSIDE THE BASE CONTAINER
LOCKING THEM IN PLACE WITH THE SMALL PARTITION AT THE BACK OF THE BASE
CONTAINER AND THE SLOTS AT THE FRONT IF THE BASE CONTAINER.
F
G
4.
5. - 6.
